Workshop Presentations
Brescia, Italy 24.11.2011
"How to make foundries more energy efficient?"
10.00 | Welcome Coffee |
10.30 | Energy efficiency in Foundries and Foundrybench -project (Markku Tapola AX-Cons Ltd) |
10.45 | Benchmarking results (Emma Svensson, SFA) |
11.10 | Good Practice Guide (Joachim Helber, IfG) |
11.20 | Case: Good practice from Italian foundry, Torbole (Mr. Padello) |
11.30 | Energy Saving: Selected Solutions of Good Practices |
| Ladle preheating (FRI, Jaczek Przybylski) |
| Cupola technologies (CTIF, Jean-Marc Piatek) |
| How to run the foundry in energy effective way? (IMMCO, Pekka Kemppainen) |
| Induction furnace good practices to reduce kwh/t & plasma new heating process for maintenance furnaces (Technalia, Patricia Caballero) |
| Heat storage – Storage of recycled energy for heating of premises, minimizing variations in the heat system and reducing peak load (SFA, Per Sommarin) |
| Induction furnace operation (IfG, Joachim Helber) |
| Heat recovery of Gas fired heat treatment furnaces and Fettling shop filtration plants (AX-Cons Ltd., Markku Tapola) |
12.45 | Discussion |
13.00 | End of Workshop and Brunch |
 | Workshop Agenda (219 kB) |
| Foundrybench Project/Tapola (3.3 MB) |
| Benchmarking/Svensson (654 kB) |
| Ladle preheating/Przybylski (2.9 MB) |
| Best Practice Module/Helber (169 kB) |
| Induction Furnace/Helber (412 kB) |
| Heat Treatment/Tapola (3.8 MB) |
| Thermal Plasma/Caballero (3.8 MB) |
| Energy Efficiency Management/Kemppainen (491 kB) |
| Heat Storage/Sommarin (421 kB) |
| Cupola Furnace/Piatek (2.4 MB) |
| High Efficient Engines/Padello (it) (86 kB) |
| High Efficient Engine/Padello (en) (84 kB) |
The sole responsibility for the content of this webpage and publications lies with the authors. It does not necessarily reflect the opinion of the European Communities. The European Commission is not responsible for any use that may be made of the information contained therein.
Foundrybench is supported by: IEE
